|本期目录/Table of Contents|

[1]李绍辉,张乐晖,曹媛媛*.一种弦式接收仪频率参量计量校准方法研究[J].工业仪表与自动化装置,2022,(04):70-73+94.[doi:10.19950/j.cnki.cn61-1121/th.2022.04.014]
 LI Shaohui,ZHANG Lehui,CAO Yuanyuan.Research on frequency parameter calibration method of vibrating wire readout[J].Industrial Instrumentation & Automation,2022,(04):70-73+94.[doi:10.19950/j.cnki.cn61-1121/th.2022.04.014]
点击复制

一种弦式接收仪频率参量计量校准方法研究

《工业仪表与自动化装置》[ISSN:1000-0682/CN:61-1121/TH]

卷:
期数:
2022年04期
页码:
70-73+94
栏目:
出版日期:
2022-08-15

文章信息/Info

Title:
Research on frequency parameter calibration method of vibrating wire readout
文章编号:
1000-0682(2022)04-0000-00
作者:
李绍辉张乐晖曹媛媛*
交通运输部天津水运工程科学研究所 国家水运工程检测设备计量站, 天津 300000
Author(s):
LI ShaohuiZHANG LehuiCAO Yuanyuan
Tianjin Research Institute for Water Transport Engineering M.O.T, National Center of Metrization Equipments of Water Transport, Tianjin 300000, China
关键词:
频率校准信号调理激励电压幅度衰减
Keywords:
frequency calibrationsignal conditionalexcitation voltageamplitude attenuation
分类号:
TH714
DOI:
10.19950/j.cnki.cn61-1121/th.2022.04.014
文献标志码:
A
摘要:
基于弦式接收仪激励信号电压幅值超出标准信号发生装置量程上限的问题,提出一种弦式接收仪频率参量计量校准方法,采用低频信号发生器为标准信号发生装置,由数字示波器判定弦式接收仪激励信号形式,通过设计对称式信号调理模块,根据激励信号电压幅值大小调整衰减倍数,在全量程范围内实现了弦式接收仪频率参量的计量校准。通过试验验证,该方法可准确判别弦式接收仪的激励信号形式、量程上下限位置,在不影响测量精度的前提下将激励电压降至安全幅值以内,频率最大示值误差0.11 Hz,3000 Hz测量点处测量不确定度U=0.22 Hz,k=2,满足最大允许误差0.3 Hz要求。
Abstract:
Based on the problem that the voltage amplitude of the excitation signal of the vibrating wire readout exceeds the upper limit of the range of the standard signal generator, a frequency parameter calibration method was proposed. A low-frequency signal generator was taken as the standard signal generator, the excitation signal form of the vibrating string frequency reader was determined by designing the symmetrical signal conditioning module, and the attenuation multiple was adjusted according to the voltage amplitude of the excitation signal. Then the calibration of frequency parameters of vibrating wire readout was realized in the full range. The experimental results show that this method can accurately distinguish the excitation signal form and the upper and lower limits of the measuring range of the vibrating wire readout instrument, reduce the excitation voltage to the safe amplitude without affecting the measurement accuracy. The maximum indication error of the frequency is 0.11hz, and the measurement uncertainty at the 3000hz measuring point is U = 0.22hz, k = 2, which are less than the maximum allowable error of 0.3hz.

参考文献/References:

[1] 李绍辉,张旭,周振杰,等. 一种弦式接收仪频率参量计量校准装置:202120256731.8[P].2021-01-29.

[2] 振弦式应变测量系统:JJG(交通)156-2020[S].2020.
[3] 周振杰,吴晓雪,赵晖. 振弦式位移计校准方法的研究[J]. 工业仪表与自动化装置,2020(1):82-84.
[4] 毛索颖,周芳芳,曹浩. 一种振弦差阻复用性读数仪的设计与实现[J]. 电子测量技术,2021,44(6):149-155.
[5] 张鑫,董旭龙,韩晓涛. 便携式大坝监测数据采集装置研制与应用[J]. 水电与抽水蓄能,2021,7(2):116-120.
[6] 车铁成,邓涛,谢荣凯. 基于振弦式传感器的桥梁施工安全监测系统设计[J]. 自动化与仪器仪表,2021(11):91-95.
[7] 田一鸣,曲立国,王尧伟,等. 基于振弦式传感器的桥梁监测系统设计及应用[J]. 中北大学学报(自然科学版),2021,42(05):468-474.
[8] 王煜,李艳萍,张博,等. 桥梁应变采集系统设计及温度效应研究[J]. 太原理工大学学报,2020,51(2):206-211.
[9] 曾麟,周四清,陈岳飞,等. 基于最小二乘法的振弦式土压力计校准研究[J]. 计量技术,2020(6):53-57.
[10] 刘权,王晓伟,贾晓杰. 振弦式应变传感器基本误差的不确定度评定[J]. 计量与测试技术,2019,46(10):104-105.

相似文献/References:

[1]张 栋,胡廷轩,雷建和,等.锁定放大微弱信号检测仿真与设计研究[J].工业仪表与自动化装置,2016,(04):40.
 ZHANG Dong,HU Tingxuan,LEI Jianhe,et al.Study on the simulation and design of weak signal detection based on lock-in amplifier[J].Industrial Instrumentation & Automation,2016,(04):40.
[2]董文厚,阮玉华.基于FPGA的LLC谐振变换器设计[J].工业仪表与自动化装置,2022,(05):3.[doi:10.19950/j.cnki.cn61-1121/th.2022.05.001]
 DONG Wenhou,RUAN Yuhua.LLC resonant converter design based on FPGA[J].Industrial Instrumentation & Automation,2022,(04):3.[doi:10.19950/j.cnki.cn61-1121/th.2022.05.001]

备注/Memo

备注/Memo:
收稿日期:2022-04-14
基金项目:中央级公益性科研院所基本科研业务费(20200202);
交通运输标准(定额)项目《振弦式应变测量系统标准及规程制修订》(2018-09-102)
作者简介:
李绍辉(1983),男,河北省保定市人,工学博士,高级工程师。研究方向为水运监测装备产业计量测试技术、港口机械计量测试技术。
更新日期/Last Update: 1900-01-01