|本期目录/Table of Contents|

[1]张鹏飞,曾 波,赵 航,等.无线温湿度采集系统的研制[J].工业仪表与自动化装置,2021,(04):81-86.[doi:10.19950/j.cnki.cn61-1121/th.2021.04.017]
 ZHANG Pengfei,ZENG Bo,ZHAO Hang,et al.Development of wireless temperature and humidity acquisition system[J].Industrial Instrumentation & Automation,2021,(04):81-86.[doi:10.19950/j.cnki.cn61-1121/th.2021.04.017]
点击复制

无线温湿度采集系统的研制

《工业仪表与自动化装置》[ISSN:1000-0682/CN:61-1121/TH]

卷:
期数:
2021年04期
页码:
81-86
栏目:
出版日期:
2021-08-15

文章信息/Info

Title:
Development of wireless temperature and humidity acquisition system
作者:
张鹏飞曾 波赵 航史占东于千源苗 芊张 勍杨荣超*
中国烟草总公司郑州烟草研究院,河南 郑州 450001
Author(s):
ZHANG Pengfei ZENG Bo ZHAO Hang SHI Zhandong YU QianyuanMIAO Qian ZHANG Qing YANG Rongchao*
Zhengzhou Tobacco Research Institute of CNTC, Henan Zhengzhou 450001, China
关键词:
WIFI单片机无线温湿度采集比对
Keywords:
WIFIsingle chip computer wireless temperature and humidity acquisitioncomparison
分类号:
TH89
DOI:
10.19950/j.cnki.cn61-1121/th.2021.04.017
文献标志码:
A
摘要:
为解决目前烟草行业温湿度计量检定布线复杂、功能简单等缺点,该文设计开发了一套基于WIFI和单片机的无线温湿度采集系统。通过试验分别对系统的精度、一致性、重复性和稳定性进行了测试,并与传统的有线采集装置进行了比对试验。结果表明:①无线温湿度采集系统的温度测量误差满足±0.1 ℃,湿度测量误差满足±1.0%RH,均满足计量检定的要求。②采用假设检验方法对一致性、重复性进行了验证,一致性测试结果P值均大于显著性水平α(0.05),重复性P值计算结果为0.766,大于显著性水平α,表明系统一致性和重复性较好;采用休哈特控制图法对稳定性进行了验证,通过温湿度
Abstract:
In order to solve the shortcomings of the metrological verification on temperature and humidity in tobacco industry, such as complicated wiring and simple functions, a wireless temperature and humidity acquisition system based on WIFI and single chip computer was proposed and designed. The accuracy, consistency, repeatability and stability of the system were tested through experiments, and correlative experiments were performed with traditional wired acquisition devices. The results show that: ①The temperature measurement error of the wireless temperature and humidity acquisition system meets ± 0.1 ℃ and the humidity measurement error meets ± 1.0% RH. And they both meet the requirements of metrological verification. ②Hypothesis testing was used to verify consistency and repeatability. The P values of the consistency test results were greater than the significance level α(0.05). The P value of the repeatability was calculated as 0.766, which was greater than the significance level α. The results show that the consistency and repeatability of the system was good. Moreover, the stability was verified by Shewhart control charts method. Judging from the temperature and humidity-R charts, the system has good long-term stability. Compared with the traditional wired acquisition device, there is no significant difference in the measurement results of temperature and humidity between the two systems. This temperature and humidity wireless acquisition system provides a more convenient and efficient measurement method for the laboratory temperature and humidity metrological verification.

参考文献/References:

[1]邹诚志,何爱民,牛小民,等.基于CFO器件的卷烟吸阻检测装置设计[J].安徽农业科学,2018,46(16):200-204.

[2] 万永强,彭春兰,李军生.纸张透气度测量值的不确定度评定[J].造纸科学与技术,2016,35(3):75-78+91.
[3] 白新亮.不同温湿度对烟用香料单体转移行为的影响研究[D].郑州:中国烟草总公司郑州烟草研究院,2012.
[4] 邹剑,郝伟,张富坤,等.卷烟烟支吸阻变化的影响因素研究[J].工程技术研究,2018(16):93-94.
[5] 石红雁,王晓婷,刘文琳.环境条件对卷烟辅助材料的影响[J].中国烟草科学,2009,30(5):46-49.
[6] 国家烟草专卖局科技司.烟草实验室大气环境检定规程:JJG(烟草)21-2010[S].北京:中国标准出版社,2021.
[7] 韩韧,金永威,王强.基于STM32和超声波测距的倒车雷达预警系统设计[J].传感器与微系统,2016,35(04):63-66.
[8] 李晶,张明明,郑永丰,等.物联网终端性能与网络协议综合测试解决方案[J].计算机测量与控制,2019,27(10):64-68+73.
[9] 贾俊平,何晓群,金勇进.统计学[M].北京:中国人民大学出版社,2015:155-165.
[10] 戴金辉.区间估计与参数假设检验的比较[J].统计与决策,2019,35(09):72-74.
[11] International Organization for Standardization. Control charts-Part2: Shewhart control charts:ISO7870-2:2013[S].

相似文献/References:

[1]熊建云.基于光电耦合器的智能仪器I/O接口电路设计[J].工业仪表与自动化装置,2013,(05):51.
[2]李明东,李世武.新型靶式流量计的设计与研究[J].工业仪表与自动化装置,2014,(05):108.
 LI Mingdong,LI Shiwu.A new type of target flowmeter based on magnetostrictive displacement sensor[J].Industrial Instrumentation & Automation,2014,(04):108.
[3]淡海英.基于AT89C51单片机的新型电水瓶电路设计与分析[J].工业仪表与自动化装置,2015,(01):114.
 DAN Haiying.A new type of electric bottle based on AT89C51 circuit design and analysis[J].Industrial Instrumentation & Automation,2015,(04):114.
[4]邹益民.S7-200 PLC与单片机间ModBus主从通信方式[J].工业仪表与自动化装置,2015,(03):19.
 ZOUou Yi-min.Research on master-slave communications between S7-200 PLC with SCM based on ModBus protocol[J].Industrial Instrumentation & Automation,2015,(04):19.
[5]夏德印,张 赛,张公全,等.光伏发电系统功率最大化方法研究与实现[J].工业仪表与自动化装置,2015,(03):48.
 XIA Deyin,ZHANG Sai,ZHANG Gongquan,et al.Study and Realization of Maximizing the Power of Photovoltaic System[J].Industrial Instrumentation & Automation,2015,(04):48.
[6]王晓侃,上官建林,朱振伟.基于PIC16F877单片机的加热炉模糊控制系统设计与研究[J].工业仪表与自动化装置,2015,(03):59.
 WANG Xiaokan,SHUANGGUAN Jianlin,ZHU Zhenwei.Design and research of heating furnace fuzzy control system based on PIC16F877 MCU[J].Industrial Instrumentation & Automation,2015,(04):59.
[7]张利民,邹益民.基于TTS模块的S7-200 PLC语音播报功能扩展[J].工业仪表与自动化装置,2015,(04):34.
 ZHANG Limin,ZOU Yimin.Extend PLC voice broadcast feature based on TTS module[J].Industrial Instrumentation & Automation,2015,(04):34.
[8]刘海旗,何军红.基于AVR单片机的红外导航无人船的设计与实现[J].工业仪表与自动化装置,2015,(04):47.
 LIU Haiqi,HE Junhong.Design and implementation of?infrared navigation unmanned?ship based on AVR[J].Industrial Instrumentation & Automation,2015,(04):47.
[9]张志成.4×4电容式触摸键盘的设计与实现[J].工业仪表与自动化装置,2015,(04):85.
 ZHANG Zhicheng.The design and implementation of 4×4 capacitive touch button[J].Industrial Instrumentation & Automation,2015,(04):85.
[10]毛 敏.光电式转速表设计[J].工业仪表与自动化装置,2015,(05):114.
 MAO Min.The design of the photoelectric tachometer[J].Industrial Instrumentation & Automation,2015,(04):114.

备注/Memo

备注/Memo:
收稿日期:2021-01-11

基金项目:
国家烟草专卖局标准修订项目(2018B005)

作者简介:
张鹏飞(1987),男,河南郑州人,硕士,工程师,主要研究方向为烟草计量、仪器仪表方面。
更新日期/Last Update: 1900-01-01